Bill
Safety Inspection Fee Amendments
- Number
- S.B. 84 First Substitute (2019GS)
- Sponsor
- Sen. Hemmert, D.
- Final action
- Governor Signed 3/21/2019
- Outcome
- Became law — signed by Gov. Gary R. Herbert
Summary
This bill raises the maximum fee for a motor vehicle safety inspection.
What it does
- This bill:
- raises the maximum fee for a motor vehicle safety inspection.
Every vote on this bill
1/30/2019Senate Comm - Held
Senate Transportation, Public Utilities, Energy, and Technology Committee
4 0 4not eligible / no record2/4/2019Senate Comm - Substitute Recommendation from # 0 to # 1
Senate Transportation, Public Utilities, Energy, and Technology Committee
6 0 2not eligible / no record2/4/2019Senate Comm - Favorable Recommendation
Senate Transportation, Public Utilities, Energy, and Technology Committee
6 0 2not eligible / no record2/15/2019Senate/ passed 2nd reading
Senate 3rd Reading Calendar
27 0 2not eligible / no record2/19/2019Senate/ passed 3rd reading
Clerk of the House
25 0 4not eligible / no record2/25/2019House Comm - Favorable Recommendation
House Transportation Committee
8 0 4not eligible / no record2/27/2019House/ passed 3rd reading
House Speaker
51 20 4NAYBill text
enrolled version · official source
SAFETY INSPECTION FEE AMENDMENTS GENERAL SESSION STATE OF UTAH Chief Sponsor: Daniel Hemmert House Sponsor: Timothy D. Hawkes LONG TITLE General Description: This bill raises the maximum fee for a motor vehicle safety inspection. Highlighted Provisions: This bill: ▸ raises the maximum fee for a motor vehicle safety inspection. Money Appropriated in this Bill: None Other Special Clauses: None Utah Code Sections Affected: AMENDS: 53-8-206 , as last amended by Laws of Utah 2017, Chapter 406 Be it enacted by the Legislature of the state of Utah: Section 1. Section 53-8-206 is amended to read: 53-8-206. Safety inspection -- Station requirements -- Permits not transferable -- Certificate of inspection -- Fees -- Unused certificates -- Suspension or revocation of permits. (1) The safety inspection required under this part may only be performed: (a) by a person certified by the division as a safety inspector; and (b) at a safety inspection station with a valid safety inspection station permit issued by the division. (2) (a) A safety inspection station permit may not be assigned, or transferred, or used at any location other than a designated location. (b) The holder of a safety inspection station permit shall post the permit in a conspicuous place at the location designated in the permit. (3) If required by the division, the safety inspector shall keep a record and file a report of every safety inspection and every safety inspection certificate issued. (4) A safety inspection station holding a safety inspection station permit issued by the division may charge a reasonable fee for labor in performing safety inspections, not to exceed: (a) [ $7 ] $14 or less for motorcycles and street-legal all-terrain vehicles; (b) unless Subsection (4)(a) or (c) applies, [ $15 ] $30 or less for motor vehicles; or (c) [ $20 ] $40 or less for 4-wheel drive, split axle, and any motor vehicles that necessitate disassembly of front hub or removal of rear axle for inspection. (5) (a) A safety inspection station may return to the division unused safety inspection certificates in a quantity of 10 or more. (b) The division shall reimburse the station for the cost of the returned safety inspection certificates. (6) (a) Upon receiving notice of the suspension or revocation of a safety inspection station permit and after the conclusion of any adjudicative proceedings upholding the suspension or revocation, the safety inspection station permit holder shall: (i) immediately terminate all safety inspection activities; and (ii) return all safety inspection certificates and the safety inspection station permit to the division. (b) The division shall issue a receipt for all unused safety inspection certificates.